Newlite 600W Closed P&P Ballast

Newlite 600W Closed P&P Ballast

BALA0042

The Newlite electromagnetic ballast 600W is a basic element in the High Pressure Sodium (HPS) Lamps and Metal Halide (MH, not CMH).

It is used as a component in lighting systems in greenhouses as well as small and medium-sized growing indoor areas, where the lamp and reflector are installed separately.

 

1. - Electronic start.

2. - EU connection wiring.

3. - Protective fuse.

4. - Ballast output connector C13 to connect with a standard cable C14 to a reflector.

5. - Allows wall installation.

Caution:
1. - Same power equipment and lamp must be verified before use.
2. - It must be installed in a dry place.
3. - Do not cover with any thermal insulation (plastic, cardboard ...) the equipment must be aerated.
4. - The ballast generates heat, it should not be touched until a few minutes after its disconnection.
5. - Wait 15 minutes before restarting the equipment to avoid damaging the lamp.
6. - It is essential to connect the ground wiring to the electrical socket and the chassis or reflector plate, as well as to make sure that the electrical installation has an adequate ground measurement to the regulations, otherwise damages will not be under guarantee .
7. - This equipment is for professional use and must be installed by qualified personnel considering the necessary cautions during its installation.

BALA0042

Download

Newlite Balastro P&P HPS

Newlite Balastro P&P HPS_en

Download (2.45M)

8 other products in the same category: