Balastro Electrónico Ignator 600W

Ignator electronic ballast 600W

BALA0054

600W electronic ballast for HPS High Pressure Sodium lamps, is used as a component in small and medium sized greenhouse lighting systems and indoor growing areas, where the lamp and reflector are installed separately. C13 ballast output connector, for connecting a standard C14 cable to a reflector.

Protection against lamp worn by use, short circuit, open circuit (lamp not installed), starting failure (lamp in bad condition) and thermal protection. Allows 15 meters of distance between the equipment and the lamp, with the appropriate wiring.


* The Digital Electronic Ballast is characterized by its high efficiency and energy savings.
* Instant start and restart.
* Lamps without flickering when it is about to run out.
* Higher performance.
* Less weight, facilitating its installation.
* Decrease of losses. increasing the efficiency of the lamp.
* Allows energy savings of up to 30%.
* Its temperature is lower.
* Silent.

Advantages of Electronic Ignator Ballasts over electromagnetic ones:

- Reduced weight.
- Elimination of flicker in the electrodes of the lamp.
- Optimum power factor (around 0.99).
- Simplification of the installation (it has only one device).
- Possibility of varying the luminous flux of the lamp (adjustable ballasts).
- Power regulator: 250W - 400W - 600W - Super Lumen.
- 250W and 400W lamps can be used by selecting the appropriate power.
- Compatible with Metal Halide and High Pressure Sodium lamps.
- Protection against a short circuit and protected in case of fluctuation of electrical current.

Specifications:

- Voltage range: 220/240 V.
- Input frequency: 50-60 Hz.
- Total Harmonic Distortion (THD): less than 10%.

BALA0054

8 other products in the same category: