PH regulators. PH UP.
This new concept of pH control will allow them to adjust and stabilize their pH level even in fast growing plants.
Using the right pH grade is essential for the perfect solubility of mineral salts and their absorption by plants.
The usual recommended level is from 5.5 to 6.5.
An ideal pH regulator is a solution that will be used only once: when you start operating your system.
Within the multiple tests we have done in our greenhouses. where we use our pH regulators. We have found the same pH level for several weeks.
In some systems the pH will go down gradually and a little pH Up will restore the balance. In others. it will perfectly stabilize around a desired 6.0.
The pH Up contains silicate.
This solution is particularly useful for growers who use reverse osmosis filters or demineralized water. to raise the pH level.
pH Up contains silicate. element whose lack can be a limiting factor in hydroponics.
Because of its limited solubility. It is difficult to incorporate into the nutrient solution.
Thus. we incorporate it into our products whenever they allow it.
Manual: in each irrigation. as much as necessary until the proper pH is achieved.
It is advised to correct and check by measuring the pH. once we have added the fertilizers to the irrigation water. since they influence him and could vary it.
Automatic: for hydro or automated irrigation. correct the pH of the water tank and check sporadically if it varies and it is necessary to correct it.