Also displays temperature from 0.0 to 60.0°C (or 32.0 to 140.0°F) The EC59 Milwaukee Instruments EC TDS Temperature Meter is ideal for agriculture, hydroponics, fish farming, aquariums, pools, laboratories, water treatment, food , education. EC TDS Meter Operation Temperature EC59 : Remove the protection; Turn on the EC59 EC TDS Temperature meter by pressing the ON/OFF/CAL button. Immerse the measurer in the liquid to be measured (better measure from a glass).

Allow a few seconds for the EC59 meter to compensate for temperature. To freeze the data, continuously press the SET/HOLD button. To switch to TDS measurement, briefly press the SET/HOLD button. To turn off the meter, press the ON/OFF/CAL button. EC TDS meter calibration EC59 Temperature: Press the ON/OFF/CAL button continuously until the message OFF is replaced by the message CAL. Then release your finger to go into calibration mode. The meter, with the message "1413uS" asks to be immersed in this calibration buffer. The meter will indicate "OK" when it is calibrated. Once calibrated in uS, the EC59 EC TDS Temperature meter is automatically calibrated in TDS (ppm). For any clarification, do not hesitate to contact us. Good measurement!

EC : Scale 0.000 to 4.000 mS (0 to 4000 uS)
TDS : Scale 0 to 2000 ppm
Resolution : 1uS, 1ppm
Temperature : 0.0 to 60.0ºC< br />Automatic calibration (1413µ/cm)
Automatic temperature compensation
Replaceable sensor-Water resistant
Batteries: 4 x 1.5V Alkaline (100h autonomy)
Auto-closing last 8mn